PDA

Afficher la version complète : Connexion Wifi ? Réglé



kirikou056
09/05/2008, 09h50
Bonjour

J'ai une carte wifi + une clé sub wifi.
Je ne sais pas comment configurer l'une ou l'autre pour me connecter, je suis en filaire pour l instant.

Ci-dessous des infos qui ne me parlent pas encore, je suis plus que débutant sur linux, j'ai installé suse hier.

Merci d'avance.

Eric

<div class='codetop'>CODE</div><div class='codemain' style='height:200px;white-space:pre;overflow:auto'>eric@linux-4stz:~> su
Mot de passe :
linux-4stz:/home/eric # hwinfo --wlan
17: PCI 207.0: 0282 WLAN controller
[Created at pci.301]
UDI: /org/freedesktop/Hal/devices/pci_14e4_4320
Unique ID: JNkJ.onk47P9RYb5
Parent ID: vuMS.fnpiWG08KJ2
SysFS ID: /devices/pci0000:00/0000:00:0e.0/0000:02:07.0
SysFS BusID: 0000:02:07.0
Hardware Class: network
Model: "Broadcom BCM4306 802.11b/g Wireless LAN Controller"
Vendor: pci 0x14e4 "Broadcom"
Device: pci 0x4320 "BCM4306 802.11b/g Wireless LAN Controller"
SubVendor: pci 0x14e4 "Broadcom"
SubDevice: pci 0x0418
Revision: 0x03
Driver: "bcm43xx"
Driver Modules: "bcm43xx"
Device File: eth1
Features: WLAN
Memory Range: 0xfeafe000-0xfeafffff (rw,non-prefetchable)
IRQ: 19 (no events)
HW Address: 00:0e:8e:00:fb:4e
Link detected: no
WLAN channels: 1 2 3 4 5 6 7 8 9 10 11 12 13
WLAN frequencies: 2.412 2.417 2.422 2.427 2.432 2.437 2.442 2.447 2.452 2.457 2.462 2.467 2.472
WLAN bitrates: 6 9 12 18 24 36 48 54 1 2 5.5 11
WLAN encryption modes: WEP40 WEP104 TKIP CCMP
WLAN authentication modes: open sharedkey wpa-psk wpa-eap
Module Alias: "pci:v000014E4d00004320sv000014E4sd00000418bc02sc80 i00"
Driver Info #0:
Driver Status: bcm43xx is active
Driver Activation Cmd: "modprobe bcm43xx"
Config Status: cfg=no, avail=yes, need=no, active=unknown
Attached to: #11 (PCI bridge)

26: USB 00.0: 0282 WLAN controller
[Created at usb.122]
UDI: /org/freedesktop/Hal/devices/usb_device_ace_1211_noserial_if0
Unique ID: V7O6.5iptQnGucc8
Parent ID: mZxt.4uPzupm_EOA
SysFS ID: /devices/pci0000:00/0000:00:02.2/usb3/3-2/3-2.4/3-2.4:1.0
SysFS BusID: 3-2.4:1.0
Hardware Class: network
Model: "ZyDAS 802.11b/g USB2 WiFi"
Hotplug: USB
Vendor: usb 0x0ace "ZyDAS"
Device: usb 0x1211 "802.11b/g USB2 WiFi"
Revision: "43.30"
Driver: "zd1211rw"
Driver Modules: "zd1211rw"
Device File: eth2
Features: WLAN
Speed: 480 Mbps
HW Address: 00:0e:2e:3f:9c:3d
Link detected: no
WLAN channels: 1 2 3 4 5 6 7 8 9 10 11 12 13
WLAN frequencies: 2.412 2.417 2.422 2.427 2.432 2.437 2.442 2.447 2.452 2.457 2.462 2.467 2.472
WLAN encryption modes: WEP40 WEP104 TKIP CCMP
WLAN authentication modes: open sharedkey wpa-psk wpa-eap
Module Alias: "usb:v0ACEp1211d4330dcFFdscFFdpFFicFFisc00ip00"
Driver Info #0:
Driver Status: zd1211rw is active
Driver Activation Cmd: "modprobe zd1211rw"
Config Status: cfg=no, avail=yes, need=no, active=unknown
Attached to: #21 (Hub)
linux-4stz:/home/eric # modprobe bcm43xx
linux-4stz:/home/eric # iwlist scanning
lo Interface doesn't support scanning.

eth0 Interface doesn't support scanning.

eth1 Interface doesn't support scanning : No such device

eth2 Scan completed :
Cell 01 - Address: 00:0F:A3:E0:FB:A3
ESSID:"Intranet"
Protocol:IEEE 802.11bg
Mode:Master
Channel:11
Frequency:2.462 GHz (Channel 11)
Encryption key:on
Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 6 Mb/s; 9 Mb/s
11 Mb/s; 12 Mb/s; 18 Mb/s; 24 Mb/s; 36 Mb/s
48 Mb/s; 54 Mb/s
Quality=100/100 Signal level=17/100
Extra: Last beacon: 160ms ago

linux-4stz:/home/eric # lsmod | grep bcm43xx
bcm43xx 419548 0
firmware_class 13568 2 bcm43xx,zd1211rw
ieee80211softmac 34432 2 bcm43xx,zd1211rw
ieee80211 35400 3 bcm43xx,zd1211rw,ieee80211softmac
linux-4stz:/home/eric #
linux-4stz:/home/eric #</div>

gibus92
10/05/2008, 09h41
Tes cartes sont reconnues, il n'y a plus qu'à les configurer dans Yast http://wiki.alionet.org/doku.php?id=howto:wifi_dans_yast

kirikou056
10/05/2008, 15h08
Merci beaucoup, problème résolu.

Agemen
10/05/2008, 20h28
Tu peux ajouter Réglé au titre? :)